Household Appliances Forum

[appliance-man]

It doesn't work at all

1. No power to the washer
Make sure there's power getting to the washer. Check for a tripped circuit breaker or a blown fuse. Check the wall socket for power. Sometimes the power cord disconnects at the washer, if this is the case, the wiring must be repaired or replaced.

2. Lid switch
The washing machine may not function if the lid switch is defective. The switch is usually located near the door. Replace if found defective.

It fills and drains at the same time

1. Drain hose
The drain hose might be too low. Make sure the drain hose is at least three feet above the floor.


It doesn't drain

1. Clogged drain line or water pump
Check to see if there's something stuck inside the pump or the drain hose connected to the pump (pump is usually located at the bottom and towards the back of the washing machine).

2. Water Pump
If the drain line isn't clogged, you may have a problem with the water pump such as a frozen pulley or a broken impeller. If that's the case replace the water pump. Note: if you have a belt driven washer, check the belt(s) for cracks, as this would be a perfect time to replace the belt(s) if needed.

No hot water

Make sure the hot water is turned on.

No cold water

Make sure the cold water is turned on.

There is no water at all

First, make sure there's water getting to the washing machine.

1. Water Inlet Valve
Replace if found defective.